Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.

woodturning tools

HSS WOOD TURNING TOOLS

  • The basic material of our HSS woodturning tools is high-alloy WOLFRAM-MOLYBDEN-STEEL, manufactured by experienced master blacksmiths. High-performance high-speed steel has decisive advantages over conventionally hardened tool steel:
  • Tempering resistance: burning is almost impossible during grinding
  • High hardness value: good edge retention even with hard woods and high turning speed
  • High wear resistance: The service life of the cutting edge compared to conventional tool steel is at least 6 times higher.
HSS WOOD TURNING TOOLS WITH ALDER WOOD HANDLE
  • working range hardness HRC 63
  • optimum cutting edge retention
  • blade fi ne polished, made of HSS steel
  • steel clamp
  • STUBAI guarantees the highest quality
  • handle made of alder wood, ergonomically shaped, unvarnished
  • end cap
BASIC HEALTH AND SAFETY INSTRUCTIONS
  • Special care is required for eyes and lungs. Always use protective glasses and dust masks!
  • Keep loose clothing and hair away from the lathe!
  • Do not start the lathe if you are under the infl uence of alcohol or drugs!
  • When you switch on the lathe, always start at a low turning speed!
  • Always use the appropriate tool for the particular job!
  • Make sure that the wood is well fi xed before you start the lathe!
  • Never try to move the wood while it is turning!
  • Never try to move the wood while it is turning!
  • Always keep your workplace clean!
  • Do not leave any shavings on the fl oor, as these are not only slippery but can also burn easily!
  • Never smoke in the workplace!